Recover Chip PIC16F883 Eeprom

Recover Chip PIC16F883 Eeprom and flash memory, it is useful to recover the content from the memory and then make PIC16F883 cloned unit which can replace these broken units:

Low-Power Features:

· Standby Current:

– 50 nA @ 2.0V, typical

· Operating Current:

– 11 ìA @ 32 kHz, 2.0V, typical

– 220 ìA @ 4 MHz, 2.0V, typical

· Watchdog Timer Current:

– 1 ìA @ 2.0V, typical

Peripheral Features:

· 24/35 I/O Pins with Individual Direction Control:

– High current source/sink for direct LED drive

– Interrupt-on-Change pin

– Individually programmable weak pull-ups

– Ultra Low-Power Wake-up (ULPWU)

· Analog Comparator Module

– Two analog comparators

– Programmable on-chip voltage reference (CVREF) module (% of VDD)

– Fixed voltage reference (0.6V)

– Comparator inputs and outputs externally accessible

Recover Chip PIC16F883 Eeprom

– SR Latch mode

– External Timer1 Gate (count enable)

· A/D Converter:

– 10-bit resolution and 11/14 channels

· Timer0: 8-bit Timer/Counter with 8-bit Programmable Prescaler

· Enhanced Timer1:

– 16-bit timer/counter with prescaler

– External Gate Input mode

– Dedicated low-power 32 kHz oscillator

· Timer2: 8-bit Timer/Counter with 8-bit Period Register, Prescaler and Postscaler

· Enhanced Capture, Compare, PWM+ Module:

– 16-bit Capture, max. resolution 12.5 ns

– Compare, max. resolution 200 ns

– 10-bit PWM with 1, 2 or 4 output channels, programmable “dead time”, max. frequency 20 kHz

– PWM output steering control

· Capture, Compare, PWM Module:

– 16-bit Capture, max. resolution 12.5 ns

– 16-bit Compare, max. resolution 200 ns

– 10-bit PWM, max. frequency 20 kHz

· Enhanced USART Module:

– Supports RS-485, RS-232, and LIN 2.0

– Auto-Baud Detect

– Auto-Wake-Up on Start bit

· In-Circuit Serial ProgrammingTM (ICSPTM) via Two Pins

· Master Synchronous Serial Port (MSSP) Module supporting 3-wire SPI (all 4 modes) and I2C™

Master and Slave Modes with I2C Address Mask

Comments are closed.