PostHeaderIcon Copy MCU PIC32MX440F512H Binary

copy-mcu-pic32mx440f512h-binary

Copy MCU PIC32MX440F512H Binary and rewrite the firmware from master Microcontroller PIC32MX440F512H to blank new Microprocessor, decapsulate the MCU PIC32MX440F512H and get access to the databus is the first step of MCU cracking;

High-Performance 32-bit RISC CPU:

· MIPS32® M4K® 32-bit core with 5-stage pipeline

· 80 MHz maximum frequency

· 1.56 DMIPS/MHz (Dhrystone 2.1) performance at 0 wait state Flash access

· Single-cycle multiply and high-performance divide unit

· MIPS16e® mode for up to 40% smaller code size

· Two sets of 32 core register files (32-bit) to reduce interrupt latency

· Prefetch Cache module to speed execution

· Operating temperature range of -40ºC to +105ºC

· Operating voltage range of 2.3V to 3.6V

· 32K to 512K Flash memory (plus an additional 12 KB of boot Flash)

· 8K to 32K SRAM memory

· Pin-compatible with most PIC24/dsPIC® DSC devices

· Multiple power management modes

· Multiple interrupt vectors with individually programmable priority

· Fail-Safe Clock Monitor Mode

· Configurable Watchdog Timer with on-chip Low-Power RC Oscillator for reliable operation

 

Peripheral Features:

· Atomic SET, CLEAR and INVERT operation on select peripheral registers

· Up to 4-channel hardware DMA with automatic data size detection

· USB 2.0-compliant full-speed device and On-The-Go (OTG) controller

· USB has a dedicated DMA channel

· 3 MHz to 25 MHz crystal oscillator

· Internal 8 MHz and 32 kHz oscillators

· Separate PLLs for CPU and USB clocks

· Two I2C™ modules

· Two UART modules with:

– RS-232, RS-485 and LIN support

– IrDA® with on-chip hardware encoder and decoder

· Up to two SPI modules

· Parallel Master and Slave Port (PMP/PSP) with 8-bit and 16-bit data and up to 16 address lines

· Hardware Real-Time Clock and Calendar (RTCC)

· Five 16-bit Timers/Counters (two 16-bit pairs combine to create two 32-bit timers)

· Five capture inputs

· Five compare/PWM outputs

· Five external interrupt pins

· High-Speed I/O pins capable of toggling at up to 80 MHz

· High-current sink/source (18 mA/18 mA) on all I/O pins

· Configurable open-drain output on digital I/O pins

Debug Features:

· Two programming and debugging Interfaces:

– 2-wire interface with unintrusive access and real-time data exchange with application

– 4-wire MIPS® standard enhanced JTAG interface

· Unintrusive hardware-based instruction trace

· IEEE Standard 1149.2-compatible (JTAG) boundary scan

 

Analog Features:

· Up to 16-channel 10-bit Analog-to-Digital Converter:

– 1000 ksps conversion rate

– Conversion available during Sleep, Idle

· Two Analog Comparators

Comments are closed.