Break IC PIC16F685 Flash

Break IC PIC16F685 Flash needs to find out the location of this flash memory, so it is necessary to understand the structure of it:

High-Performance RISC CPU:

· Only 35 instructions to learn:

– All single-cycle instructions except branches

· Operating speed:

– DC – 20 MHz oscillator/clock input

– DC – 200 ns instruction cycle

· Interrupt capability

· 8-level deep hardware stack

· Direct, Indirect and Relative Addressing modes

Special Microcontroller Features:

· Precision Internal Oscillator:

– Factory calibrated to ± 1%

– Software selectable frequency range of 8 MHz to 32 kHz

– Software tunable

– Two-Speed Start-up mode

– Crystal fail detect for critical applications and Break IC PIC16F873A Code

– Clock mode switching during operation for power savings

· Power-Saving Sleep mode

· Wide operating voltage range (2.0V-5.5V)

· Industrial and Extended Temperature range

· Power-on Reset (POR)

· Power-up Timer (PWRTE) and Oscillator Start-up Timer (OST)

· Brown-out Reset (BOR) with software control option

· Enhanced low-current Watchdog Timer (WDT) with on-chip oscillator (software selectable nominal 268 seconds with full prescaler) with software enable

· Multiplexed Master Clear/Input pin

· Programmable code protection to prevent the MCU Cracking

· High Endurance Flash/EEPROM cell:

– 100,000 write Flash endurance

– 1,000,000 write EEPROM endurance

– Flash/Data EEPROM retention: > 40 years

· Enhanced USART module:

– Supports RS-485, RS-232 and LIN 2.0

– Auto-Baud Detect

– Auto-wake-up on Start bit

Low-Power Features:

· Standby Current:

– 50 nA @ 2.0V, typical

· Operating Current:

– 11 ìA @ 32 kHz, 2.0V, typical

– 220 ìA @ 4 MHz, 2.0V, typical

· Watchdog Timer Current:

– <1 ìA @ 2.0V, typical for the purpose