Recover MCU PIC16F73 Binary from flash memory and data extracted from eeprom memory of Microcontroller, reprogramme the firmware into blank MCU PIC16F73 for Microprocessor cloning;

Recover MCU PIC16F73 Binary from flash memory and data extracted from eeprom memory of Microcontroller, reprogramme the firmware into blank MCU PIC16F73 for Microprocessor cloning

High Performance RISC CPU:

· High performance RISC CPU

· Only 35 single word instructions to learn

· All single cycle instructions except for program branches which are two-cycle

· Operating speed: DC – 20 MHz clock input DC – 200 ns instruction cycle

· Up to 8K x 14 words of FLASH Program Memory, Up to 368 x 8 bytes of Data Memory (RAM)

· Pinout compatible to the PIC16C73B/74B/76/77

· Pinout compatible to the PIC16F873/874/876/877

· Interrupt capability (up to 12 sources)

· Eight level deep hardware stack

· Direct, Indirect and Relative Addressing modes

· Processor read access to program memory

Special Microcontroller Features:

· Power-on Reset (POR)

· Power-up Timer (PWRT) and

Oscillator Start-up Timer (OST)

unlock PIC16F73 microprocessor fuse bit and open mcu flash memory and eeprom memory to readout heximal program and binary data

· Watchdog Timer (WDT) with its own on-chip RC oscillator for reliable operation

· Programmable code protection

· Power saving SLEEP mode

· Selectable oscillator options

· In-Circuit Serial Programming (ICSP) via two pins

Peripheral Features:

· Timer0: 8-bit timer/counter with 8-bit prescaler

· Timer1: 16-bit timer/counter with prescaler, can be incremented during SLEEP via external crystal/clock

· Timer2: 8-bit timer/counter with 8-bit period register, prescaler and postscaler

· Two Capture, Compare, PWM modules if Recover mcu binary

– Capture is 16-bit, max. resolution is 12.5 ns

– Compare is 16-bit, max. resolution is 200 ns

– PWM max. resolution is 10-bit

recover pic16F73 mcu chip flash memory code and clone the program firmware to new microcontroller

· 8-bit, up to 8-channel Analog-to-Digital converter

· Synchronous Serial Port (SSP) with SPI (Master mode) and I2C (Slave)

· Universal Synchronous Asynchronous Receiver Transmitter (USART/SCI)

· Parallel Slave Port (PSP), 8-bits wide with external RD, WR and CS controls (40/44-pin only)

· Brown-out detection circuitry for Brown-out Reset (BOR)

Comments are closed.